Go into setup mode by holding down the "Ent" button while powering
up. Choose "Device Sel". You can map interface widgets (switches,
etc) to channels there.
Good luck! -Jim Laurel
On Nov 30, 2005, at 9:32 AM, Walt W5SWA wrote:
I am trying to setup a 9303 to control a rudder, elev., flap only
LMR type sailplane using a 6ch rx. Presently I have the elev on ch
#3 and the rudder on ch #4 and the flaps controlled by the stick on
ch #5 (in device sel I activated the motor on this channel but i am
using it (ch 5) to control the flaps). Everything is working
fine. But I am trying to figure out how to control the motor on ch
#6 using one of the switches on the tx (just on/off). Is it
possible to use one of the Aux# on ch 6 to control the motor?
The trouble is that this is my first JR radio (all prior radios
were Airtronics Vision and Stylus). So, first of all can it be
done on a 6 ch rx or do I need more channels. Secondly, if it can
be done on 6 channels how is it done. I don't need step by step
instructions just some help getting me started in the right direction.
Thanks
Walt
W5SWA
RCSE-List facilities provided by Model Airplane News. Send
"subscribe" and "unsubscribe" requests to soaring-
[EMAIL PROTECTED] Please note that subscribe and unsubscribe
messages must be sent in text only format with MIME turned off.
Email sent from web based email such as Hotmail and AOL are
generally NOT in text format
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe
messages must be sent in text only format with MIME turned off. Email sent from web based email
such as Hotmail and AOL are generally NOT in text format