Hi,
I get the following message when I execute “ ip link set can0 up type can
bitrate 125000”
-RTNETLINK answers: Operation not supported.
Please revert back with a solution if anyone has come across this.
Driver-FlexCAN driver from freescale.
Processor –i.MX35
Iproute2 – V2.6.31
kernel version-2.6.35
dmesg o/p –
Freescale FlexCAN Driver
CAN device driver interface
can: controller area network core (rev 20090105 abi 8)
can: raw protocol (rev 20090105)
can: broadcast manager protocol (rev 20090105 t)
Ifconfig –a command shows gives the following output –
can0 Link encap:UNSPEC HWaddr
00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
NOARP MTU:16 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:64
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Thanks,
Best Regards,
Nikhil
Larsen & Toubro Limited
www.larsentoubro.com
This Email may contain confidential or privileged information for the intended
recipient (s) If you are not the intended recipient, please do not use or
disseminate the information, notify the sender and delete it from your system.
_______________________________________________
Socketcan-users mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/socketcan-users
