Hello,

Thanks for all this information. And, basically the issue is the fact that no 
can network interface shows up.

If I boot with the Kvaser device plugged, I could well see it using:
 Lsusb

...but 
 sudo ip link list
...does not reveal any can interface while I have loaded these modules: can, 
can-raw, can-dev, kvaser-usb.
...while dmesg displays "usbcore: registered new interface driver kvaser_usb"...

In addition, if I hotplug Kvaser device, I get a kernel panic.

So, I have probably made a mistake when I have built the kernel.

Cheers,

Pierre 

 
-----Message d'origine-----
De : [email protected] 
[mailto:[email protected]] De la part de Max S.
Envoyé : mardi 7 janvier 2014 16:17
À : [email protected]
Objet : Re: [Socketcan-users] Beginner question - Kvazer USB CAN driver

Hello,

I'm not sure about the kvaser in particular, but the driver should create the 
network interfaces when the USB device is attached.

so no need to add a new socketcan device.

Check to make sure you have kvaser connected:
        lsusb

Check to make sure kvaser driver has made network interfaces:
        sudo ip link list

Then bring the interface up:
        sudo ip link set can0 up type can bitrate 250000

Listen to some frames:
        candump can0

Depending on how you have permissions set up you will require sudo to use most 
of the ip commands.

Regards,
Max Schneider

On Tue, 2014-01-07 at 14:17 +0000, GARNERO, PIERRE (P.) wrote:
> Hello.
> 
>  
> 
> I would like to use a KVAZER USBcan Rugged device with the socketcan 
> library.
> 
> I use Raspbian OS and I have built a kernel with anything enabled 
> regarding CAN.
> 
>  
> 
> I have loaded the following modules:
> 
> # modprobe can
> 
> # modprobe vcan
> 
> # modprobe can-raw
> 
> # modprobe can-dev
> 
> # modprobe kvazer-usb
> 
>  
> 
> But any ip link command (ex: ip link add dev can0 type can) failed 
> with “RTNETLINK answer : operation not permitted” (excepted for vcan 
> which works well).
> 
>  
> 
> Could someone provide me some hints regarding the steps to have a 
> Kvaser USBcan device up and running using the net driver ?
> 
>  
> 
> Many thanks in advance,
> 
>  
> 
> Pierre
> 
>  
> 
>  
> 
>  
> 
>  
> 
>  
> 
> 
> _______________________________________________
> Socketcan-users mailing list
> [email protected]
> https://lists.berlios.de/mailman/listinfo/socketcan-users


_______________________________________________
Socketcan-users mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/socketcan-users
_______________________________________________
Socketcan-users mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/socketcan-users

Reply via email to