I suggest using a long grid surface as a base instead of curves. Perhaps this will help , if I understand correctly: http://www.xsibase.com/forum/index.php?board=11;action=display;threadid=45923;start=15
-manny From: softimage-boun...@listproc.autodesk.com [mailto:softimage-boun...@listproc.autodesk.com] On Behalf Of Szabolcs Matefy Sent: Friday, May 25, 2012 8:51 AM To: softimage@listproc.autodesk.com Subject: Extrud questions Hey folks, Does anybody know, if there is solution to the following issue. I have a minigun and an ammo backpack. I have to make the ammo belt. I have to make sure, that the beginning and the ending cross-section fits into the slots. Technically I want to make sure, that the extrusion starts from a given profile and ends in a given profile without any roll and so on that used the happen in XSI. Huh Cheers Szabolcs ___ This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version. Crytek GmbH - http://www.crytek.com - Grüneburgweg 16-18, 60322 Frankfurt - HRB77322 Amtsgericht Frankfurt a. Main- UST IdentNr.: DE20432461 - Geschaeftsfuehrer: Avni Yerli, Cevat Yerli, Faruk Yerli
<<attachment: winmail.dat>>
