Dunno in relation to clone points, but execute nodes going into cases of a
select case node definitely works.
I use it mostly with a get data > state ID driving the select case and
plugging an execute in each case and pretty much anything you want going
into the executes - resulting in a simplified state machine.
So far, I haven't run into situations where this didn't work as I would
hope - not that I'd claim pushing it as far as it'll go.
It might be important what you drive the select case node with, and if
perhaps that condition is changing dynamically based on what you are doing
in the different cases. You could perhaps get into a problematic cycle, but
I haven't had it happen to me yet.
-----Original Message-----
From: Fabricio Chamon
Sent: Wednesday, June 20, 2012 9:45 PM
To: softimage@listproc.autodesk.com
Subject: Re: Issue using Select Case with Clone Point
oh, I'm almost 100% sure this very same subject came up a while ago
and this was the final word. Maybe this has changed over versions ?
anyways, nice to know! thanks Stephen