Today I hooked up my scanner to my Sparc LX for fun, but when I booted Linux
I got these errors:
esp0: IRQ 36 SCSI ID 7 Clock 40 MHz CCF=8 Time-Out 167 NCR53C9XF(espfast)
detected
esp0: FAST chip is fas100a (family=0, version=2)
ESP: Total of 1 ESP hosts found, 1 actually in use.
QPTI: Total of 0 PTI Qlogic/ISP hosts found, 0 actually in use.
scsi0 : Sparc ESP100A-FAST
scsi : 1 host.
Vendor: SEAGATE Model: ST11200N Rev: 9300
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 3, lun 0
Vendor: RELISYS Model: VM3530+ Rev: 1.06
Type: Scanner ANSI SCSI revision: 02
Detected scsi generic sgb at scsi0, channel 0, id 4, lun 0
scsi : detected 1 SCSI disk total.
esp0: target 3 [period 100ns offset 15 10.00MHz FAST SCSI-II]
SCSI device sda: hdwr sector= 512 bytes. Sectors= 2059140 [1005 MB]
[1.0 GB]
sunlance.c:v1.9 21/Aug/96 Miguel de Icaza ([EMAIL PROTECTED])
eth0: LANCE 08:00:20:04:44:64
eth0: using auto-carrier-detection.
Partition check:
sda: sda1 sda2 sda3 sda4 sda5 sda6 sda7 sda8
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 40k code, 4k data
scsi : aborting command due to timeout : pid 21, scsi0, channel 0, id 3,
lun 0 Read (6) 00 02 9a 0e 00
esp0: Aborting command
esp0: dumping state
esp0: dma -- cond_reg<a6400310> addr<f278d600>
esp0: SW [sreg<11> sstep<04> ireg<10>]
esp0: HW reread [sreg<01> sstep<dc> ireg<00>]
esp0: current command [tgt<03> lun<00> pphase<CLUELESS> cphase<DATAIN>]
esp0: disconnected
SCSI host 0 abort (pid 21) timed out - resetting
SCSI bus is being reset for host 0 channel 0.
esp0: Resetting scsi bus
esp0: Gross error sreg=40
esp0: SCSI bus reset interrupt
Is there something wrong here? This is with kernel 2.0.33. I had been
useing 2.2.0pre7+sparc patches for about a week but when I rebooted my
machine for some reason it wouldnt boot the 2.2 kernel...
--
.- - -- - --- -----------------+--------------------+
John Kozan, [EMAIL PROTECTED] | PGP Fingerprint: |
3C6E 2AC4 7719 24E9 4A0D 4996 9E61 1DAE 4C4B C00A |
finger [EMAIL PROTECTED] for PGP public key |
http://kozan.net1fx.com |
---------------------------------------------------+
-
To unsubscribe from this list: send the line "unsubscribe sparclinux" in
the body of the message to [EMAIL PROTECTED]
