You would seem to need some more options. Note: I am baseing this on what
the man page says, I just use the prebuilt image (available from fine mirror
sites everywhere) You need these two options (at least)
-s silo_conf_file
Specifies the path and filename of the SILO config�
uration file to be used when making a "SILO"
bootable CD. The pathname must be relative to the
source path specified to mkisofs and start with a
slash. The default is /etc/silo.conf See SILO doc�
umentation for the syntax of this file.
-S silo_bootblock
Specifies the path and filename of the SILO first
stage boot image to be used when making a "SILO"
bootable CD. The pathname must be relative to the
source path specified to mkisofs. The default is
boot/cd.b The boot image must come from SILO 0.8.7
and higher.
I doubt these are the only options, so I would still reccomend a stroll
through the man page. HTH HAND
Mark
--
Mark Nejedlo [EMAIL PROTECTED]
http://www.cs.wisc.edu/~nejedlo
"Fire bad, tree pretty."
-- Buffy Summers
-
To unsubscribe from this list: send the line "unsubscribe sparclinux" in
the body of the message to [EMAIL PROTECTED]
