Hi Ales, Thnx, but is there anywhere after discovery that Spectrum says it was connected to this before, and this is new connection now (something like connections change mgmt). I didn't find any event like that.
Nice regards, ivana -- Ivana "Mahdal Ales" <[email protected]> 10.02.2009 16:23 Please respond to "Mahdal Ales" <[email protected]> To "spectrum" <[email protected]> cc Subject RE: [spectrum] tracking changes in topology change in Spectrum Ivana, Have a look to the Reconfiguration options of the IPphone model. There is an option to define f SS should reconfigure model when interfaces go up/down. …more details are in „Modeling your infrastructure….“ Doc. Page95. See extract bellow. HTH, Ales Automatically Updating Device Interface and Connection Information You can use the following attributes to configure SPECTRUM to automatically update interface and connection information about a device. Automatically Reconfigure Interfaces SPECTRUM automatically discovers and models device interfaces after the number of configured interfaces for a device changes if the Automatically Reconfigure Interfaces attribute is set to Yes. The updated interface information appears in the Interfaces view for the device. Discover Connections After Link-Up Events SPECTRUM automatically discovers and maps a model’s connections one poll interval after it receives a LINK up trap from a device when the Discover Connections After Link-Up Events attribute is set to Yes. This delay lets the device fully reconfigure its related SNMP tables before SPECTRUM reads them. The Poll Interval setting for the device appears in the Information view, SPECTRUM Modeling Information subview. See SNMP Communication Attributes on page 157 for information about the Poll Interval setting. From: [email protected] [mailto:[email protected]] Sent: Tuesday, February 10, 2009 3:55 PM To: spectrum Subject: [spectrum] tracking changes in topology change in Spectrum Dear Spectrum list users, We have a requirement to track changes when ip phone changes it's port. All ip phones are discovered and in Spectrum connected to appropriate switches. Any ideas? So far Spectrum just alarms when phone is disconnected and clears alarm when phone is connected again to another port. But I cannot see anywhere that Spectrum says topology is changed (old and new port) Any help is greatly appreciated. -- Ivana --To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected] --To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected] --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
