CLI question: I need to run a CLI command on my Spectroserver dump a list of all devices of a certain model type. I tried using the ./show models mth=XXXXXXX option but it does like my syntax. Can anyone set me on the right path? It's been so long since I've used the CLI I've forgotten most of the syntax.
Thanks. Thanks. Andy Stein Duke Medicine Network and System Management Technologies [email protected] Office (919) 681-2739 Mobile (919) 402-7627 "Pfleger, Jim" <[email protected]> 01/19/2010 04:32 PM Please respond to "Pfleger, Jim" <[email protected]> To "spectrum" <[email protected]> cc Subject Re: [spectrum] Troubleshooting undiscovered links Thank you for the responses David and Mitch. One device is a Cisco 3750 with CDP, but the other is a Cisco ASA, which doesn’t support CDP. I’ve got another ASA on the same switch where both links discovered properly. Additionally, the discovery debug shows that the missing connection was found at layer 2 but it looks like it was discarded at layer 3. I’ve bundled all this up and sent it to Support. If I get anything interesting back, I’ll update the thread. Jim On 1/17/10 9:42 AM, "david t. klein" <[email protected]> wrote: By default, Cisco routers and switches will emit CDP out all interfaces, though recommended practice is to turn it down on interfaces that support the edge (either non-trunk ports on access switches or ports on routers where a hand-off is performed (such as to a vendor, WAN/Internet provider, VPN or extranet). -- david t. klein Cisco Certified Network Associate (CSCO11281885) Linux Professional Institute Certification (LPI000165615) Redhat Certified Engineer (805009745938860) Quis custodiet ipsos custodes? From: Wilkerson, Mitch [mailto:[email protected]] Sent: Sunday, January 17, 2010 10:16 AM To: spectrum Subject: RE:[spectrum] Troubleshooting undiscovered links If in a Cisco environment, is CDP enabled across the board? Thank You, Mitchell Wilkerson Networking Specialist NC Office of Information Technology Services 919-754-6120 ***************************************************************** * E-mail correspondence to and from this address may be subject * * to the North Carolina Public Records Law and may be disclosed * * to third parties by an authorized state official. * ***************************************************************** From: Pfleger, Jim [mailto:[email protected]] Sent: Friday, January 15, 2010 3:43 PM To: spectrum Subject: [spectrum] Troubleshooting undiscovered links Hello all- We’re rolling Spectrum out in earnest, which includes discovering a large number of devices. We’ve come across a few connections between SNMP-managed devices that are not automatically modeled. Does anyone have any suggestions how to troubleshoot discovery issues like these? I didn’t see any in either the docs or on the wiki. Thank you, Jim --To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected] --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
