You should be able to create a "Set Script" that runs an SNMP Set to save the running config (described in https://supportforums.cisco.com/thread/176806). Then create a SANM policy that runs on this specific event code (you'll need to consult your One Click to get the mapping of that tap OID to a SpecHex event code) and kicks off the Set Script you created earlier. Not terribly hard (we did similar, back when I helped manage a Spectrum buildout).
If you need help with this, CA support can point you to the right Spectrum manual; if you need specific help writing it, JJ's organization (I forget her last name, but JJ is awe-inspiring and stuff) has some pretty good consultants for Spectrum who can setup a Professional Services engagement to help you write and document the script. Hope it helps, -DTK -- david t. klein Cisco Certified Network Associate (CSCO11281885) Linux Professional Institute Certification (LPI000165615) Redhat Certified Engineer (805009745938860) Quis custodiet ipsos custodes? From: Fereydoon Mallahi Karai [mailto:[email protected]] Sent: Wednesday, September 11, 2013 1:00 PM To: spectrum Subject: [spectrum] STARTUP AND RUNNING CONFIGURATIONS ARE DIFFERENT Hi, We receive "STARTUP AND RUNNING CONFIGURATIONS ARE DIFFERENT" alarm for some devices. I wonder if there is a way to save the "running configuration" of a device throw Spectrum. Thank you. Regards, Ferey * --To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected] _____ No virus found in this message. Checked by AVG - www.avg.com Version: 2013.0.3392 / Virus Database: 3222/6661 - Release Date: 09/12/13 --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
