What a nightmare. Thank goodness for tons of old manuals. After 12 'custom' tool designs/attempts... I finally got the trim..into the groove in the seal of the rear hatch glass. Figures.... NO manual tells you how to install it This is the little 'T' shaped trim that sticks down into the round groove in the rubber itself.
This is where/why I was asking about 'modifying' the rubber before. In an old Vitesse manual... was one/two sentences... no pics.... You're suppose to put it in the groove 'BEFORE' you install the seal and glass into the hatch! GREAT! I had just finished installing the new seal and passed a 'third brake light' wiring down around the seal. NO WAY I WAS GOING TO PULL IT OUT to do over again just for the trim. Now the worst part. I had an original, real metal, stainless steel MK!? MKII? MKIII 'T' shaped front windshield trim pieces here... So I straightened out the bends and re-bent them to follow the curves of the rear hatch seal. BUT COULDN'T GET THEM IN. was really p___ off when I found how they were 'supposed' to be installed. Well....I found a way anyway. Made bunch of tiny tools and it's in. NOW FOR THE BIGGie... How many people actually put sealant around the glass IN the grooves of the seal for the glass AS WELL AS the body metal grooves. Apparently all these grooves are suppose to be sealed up with mastic or Plastisol. So... now that the rubber is all nice and tight...I get to try and lift the edges to cram the tip of a silicone sealant tube in the there to seal everything... Ha..... live and learn. Paul Tegler [EMAIL PROTECTED] www.teglerizer.com /// [EMAIL PROTECTED] mailing list /// Send admin requests to [EMAIL PROTECTED] /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http://www.team.net/archive /// Send list postings to [EMAIL PROTECTED] /// Edit your replies! If they include this trailer, they will NOT be sent.
