In a message dated 2/13/2004 8:38:47 AM Eastern Standard Time, [EMAIL PROTECTED] 
writes:

> I own a Spitfire 1970 MK 3 with a 3-synchro gearbox, how complicated is it
> to Upgrade to a 4-synchro box,(I mean buy a new 4-synchro box for
> replacement) in reference to drive shaft length bell housing etc. the actual
> gearbox need to be rebuilt and Spitbits sell a standard one for $450.00 for
> a 3-synchro I think. Any comments
> Have a very nice day
> Paul-Ernest

As I recall, the 4-synchro box is a whopping 5/8" longer. That's usually not enough to 
force a change in the driveshaft; many driveshafts were of the sliding joint variety 
and will accommodate the ever-so-slightly longer box.

The output flange normally was larger on the 4-synchro box and will NOT mate up with 
the (presumably) original flange on the driveshaft. Either obtain a larger flange for 
the driveshaft, or you may be able to swap your old output flange onto the "new" 
gearbox(not positive about this?).

--Andy Mace

***     http://www.team.net/the-local    ***

Your messages not reaching the list?
Check out http://www.team.net/posting.html

***  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
***  http://www.team.net/cgi-bin/majorcool
***  http://www.team.net/mailman/listinfo
***  Archives at http://www.team.net/archive
***  Edit your replies!

Reply via email to