In the factory (or Bentley) service manual, item #43 on page 10.00.17 says:
1: Wipe clean plug and surrounding area. 2: Remove the plug. 3: Fit a suitable grease nipple to the plug hole. 4: Apply a grease gun to the nipple, and stroke for 5 times only. CAUTION: Over greasing can cause damage to the rubber bellows. You could jam in a tapered-thread grease fitting and leave it in place, but it might not properly hold the ground wire terminals that are under it. Doug At 12:46 PM 11/1/2004 -0600, you wrote: >The Haynes manual shows a grease fitting in the cap. The only instructions >about grease, in any of the manuals, is for the ball joint in the rack. It >says use 2 cc's of grease on the ball joints and in the gaitors. No mention >of how much grease goes in the pinion box. > >If I turn it full left and coat the rack with grease, then full right and >coat that side with grease, would that be sufficient? > >Larry *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!