Usually there is an example already out there that can be cut-n-pasted with little modifications. Another vote for Bluebeam. Great too. Just take a Bluebeam snap-shot of the item and paste it into your document. You can even save it as a stamp or tool chest item for later. You can always do a screen shot (<SHIFT> <PrtScn>) then paste (Cntrl V) into a Word document. If you're looking to create it from scratch w/o Bluebeam or CAD, I've had the best luck with PowerPoint.
Travis Travis E. Allen, PE Allen Engineering, PLLC From: Hinson, Ryan [mailto:[email protected]] Sent: Monday, April 10, 2017 12:14 PM To: [email protected] Subject: RE: Sketching software Bluebeam Ryan L. Hinson, PE*, SET** \ Burns & McDonnell Senior Fire Protection Engineer O 952-656-3662 \ M 320-250-5404 \ F 952-229-2923 [email protected] \ <http://www.burnsmcd.com/> burnsmcd.com 8201 Norman Center Drive, Suite 300 \ Bloomington, MN 55437 *Registered in: MN, PA, & TX **NICET IV - Water-Based Systems Layout From: Sprinklerforum [mailto:[email protected]] On Behalf Of Scott Futrell Sent: Monday, April 10, 2017 12:24 PM To: [email protected] Subject: Sketching software Does anyone have suggestions for software to make good, neat, details for use on a desktop or Android tablet? Not AutoCad or HydraCad, just something to use to make details to put in reports, letters, presentations. To make details of pipe and fittings both above ground and underground? Thanks in advance, Scott Futrell Futrell Fire Office: (763) 425-1001 x 2 Cell: (612) 759-5556
_______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
