gunnar wrote: > Trying to resurrect my old SB-players, and connect them to > mysqueezebox.com. I have 5 receivers, and two sb-3 classics. mherger > helped me removing the players from the database, and I was then able to > connect both sb3s, and one of the receivers to mysqueezebox.com. All the > players are now listed on mysqueezebox.com, but only the two sb3s, and > one receiver can be connected. All players can connect to my LMS, > running on a qnap nas. The last receiver is defective (I think, emitting > purple flashes). I get a little different error messages when trying to > connect (settings->advanced->network->mysqueezebox.com). Usually the > message is "can`t resolve ipaddress for mysqueezebox.com". Then the > player section at mysqueezebox.com say that the player is not connected. > I also sometimes get a different message, something that it was not > possible to connect, check that the LMS is running etc.. The player > usually connects anyway, despite this message. Not sure what the correct > procedure is to connect the players. Tried to reset the controller to > factory settings, and during the setup I am asked if I have a > mysqueezebox account. I can then register to my existing account. But I > guess this only registers the controller, not the connected player? Also > tried to reset the receivers by holding the button until red, rapid > flash. For some reason the menues isn`t consistant, eg sometimes I have > a settings->advanced->information menu, where I eg. can see the > information for my mysqueezebox account. Sometimes this menu isn`t here.
Im not sure how much help I can be as I don't have any of my receivers at my current location, and I really don't use mysb.com (i.e. haven't reset receivers to go directly to mysb.com). Also, you say that all players can connect to LMS, so that would tell me that the hardware is behaving??? My only thoughts - 1) All my receiver problems have been due to connecting via wifi, try ethernet at least just temporarily. 2) I always reset my receivers and controllers together. That is, if I have to reset a receiver, I reset a controller to help through the setup. I have neve had any luck just resetting the receiver. a) Press and hold button on receiver until fast red flash that will eventually go to slower red flash. b) Power off controller. Hold '+' as you press power button until buttons flash then release. c) when the controller comes up it goes through the process of connecting to the network, then finding a receiver, at which point the receiver buttons go through the light change process. 3) Remember too that mysb.com only shows the players "connected" if they are indeed connected to mysb.com, not if they are connected to LMS. If things are working well you can switch back and forth - "connect to my sb.com" and "my music" takes you back to LMS. You mention some messages you receive, some seem to be from the players, some from mysb.com? Maybe if you just shut down LMS for the time being and focus only on mysb.com, to eliminate some of the confusion/variables. A few shots in the dark.... Jim ------------------------------------------------------------------------ Redrum's Profile: http://forums.slimdevices.com/member.php?userid=33806 View this thread: http://forums.slimdevices.com/showthread.php?t=72548 _______________________________________________ squeezenetwork mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/squeezenetwork
