Hi ,
I have a same problem . Thanks edward for mentioning router config . I
am using wccp 1.0 method for intercepting web request to the squid box
and I have to store that the sattelite Ip of the squid should not
redirect to the squid box again . That's solved the problem .
--
Regards
=================================================================
/ Seyyed Hamid Reza / WINDOWS FOR NOW !! /
/ Hashemi Golpayegani / Linux for future , FreeBSD for ever /
/ Morva System Co. / ------------------------------------- /
/ Network Administrator/ [EMAIL PROTECTED] , ICQ# : 42209876 /
================================================================
-----Original Message-----
From: Edward D. Millington [mailto:[EMAIL PROTECTED]
Sent: Thursday, February 27, 2003 4:05 AM
To: Hamid Hashemi Golpayegani
Subject: Re: [squid-users] tcp_outgoing_address problem !
Are you doing policy routing?
You need to allow both squid ips in the policy.
Eg.
access-list 110 deny tcp host 81.12.18.2 any
access-list 110 deny tcp host 62.112.164.193 any
access-list 110 permit tcp any any
route-map squidcaching permit 110
match ip address 110
set ip next-hop 81.12.18.2
Thank you very much.
Best regards
Edward Millington
BSc, Network+, I-Net+, CIW Professional
Systems Administrator, Sr
Cariaccess Communications Ltd.
Palm Plaza
Wildey
St. Michael
Barbados
Phone: 1 246 430 7435
Mobile: 1 246 234 6278
Fax: 1 246 431 0170
[EMAIL PROTECTED]
www.cariaccess.com
-----Original Message-----
From: "Hamid Hashemi Golpayegani" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Date: Thu, 27 Feb 2003 01:38:37 +0330
Subject: [squid-users] tcp_outgoing_address problem !
> Hi ,
>
> I have a working squid 2.5 Stable 1 that using an internet connection
> through eth0 card with a default route added to routing table . For
> some reason I have setup a one way receive only sattelite DVB receiver
> and I want to use this link for some IP classes . Then I used
> tcp_outgoing_address . My network plan is like this :
>
> eth0 -> 81.12.18.2 81.12.18.10
> |-----------| |----------------------|
> |-------------------------|
> | squid box |-------| Catalyst 2950 switch |------| Broadlogic DVB
> Receiver |----( Sattelite Dish and LNB Receiver ) <-------
> 62.112.164.192/255.255.255.192
> |-----------| |----------------------|
> |-------------------------|
> eth0:0 -> 62.112.164.193 |
> |
> |----------------------|
> | Cisco 2650 Router | 81.12.18.1
> |----------------------|
> |
> |
> DSL Connection
>
> As you can see there two different classes the 81.12.18.0/24 is routed
> through DSL connection from send and receive internet and
> 62.112.164.192/255.255.255.192 is routed through DSL for sending
> packets and receiving through DVB Receiver . So the Squid box have two
> different IP address that each one from one of these classes . There
> is a network card the I stored Secondary IP address on the interface .
> The squid ip address is 81.12.18.2 is DSL class IP address and
> 62.112.164.193 is DVB class IP address . I have tried pinging
> yahoo.com on squid box with this command : ping yahoo.com , and all
> things well cause sending and receiving is throgh DSL link .
> The I tried ping yahoo.com with this command : ping -I 62.112.164.193
> yahoo.com , and also all things well cause sending is through DSL
> link and receiving is through sattelite DVB receiver .
> As you can see there is no problem is our DVB connection and network
> plan . After this I tried to configure squid to use the sattelite
> connection for some specific address with this configuration :
>
> acl specific_ips src 81.12.18.192/255.255.255.192 tcp_outgoing_address
> 62.112.164.193 specific_ips tcp_outgoing_address 81.12.18.2
>
> Also the default route of the squid box is 81.12.18.1 and all
> sattelite Ips are routed to squid box on Broadlogic . The problem is
> that the normal IP addresses ( instead of specific_ips
> ) is working well through normal DSL connection and IP address and
> nothing happened to them . But the specific_ips that should use
> sattelite link is not working and no webpage could browsed . I tried
> netstat and it shows that the connection from source 62.112.164.193 to
> target host is tried to established and added to netstat list . But
> there is no web browsing ! Any idea ?
>
> --
> Regards
>
> =================================================================
> / Seyyed Hamid Reza / WINDOWS FOR NOW !! /
> / Hashemi Golpayegani / Linux for future , FreeBSD for ever /
> / Morva System Co. / ------------------------------------- /
> / Network Administrator/ [EMAIL PROTECTED] , ICQ# : 42209876 /
> ================================================================
