The service is up but is not getting any content from the destination server. Is there a line I need to change to make it forward traffic to my target server?
Thanks -----Original Message----- From: Amos Jeffries [mailto:[EMAIL PROTECTED] Sent: Tuesday, September 16, 2008 7:38 AM To: Gustavo Lazarte Cc: squid-users@squid-cache.org Subject: Re: [squid-users] Fedora Gustavo Lazarte wrote: > I upgraded and now when I am trying to use my squid server to send traffic to > the site 10.2.0.140 the squid server IP is 10.2.0.150. > > I also get the Warning cannot write the log file Permission denied. > > Then I try the /usr/local/squid/sbin/squid I get cannot write cache.log > Permission denied. I use the user nobody for > cache_effective_user Ah, well, you need to set read+write permission on the log file directory squid is trying to use and the logs inside it. > /usr/local/squid/sbin/squid -z runs correctly > Thats good. At least the storage area won't have more of these problems when squid does start. Amos > > Thanks > > > > > -----Original Message----- > From: Amos Jeffries [mailto:[EMAIL PROTECTED] > Sent: Saturday, September 13, 2008 11:39 AM > To: Gustavo Lazarte > Cc: squid-users@squid-cache.org > Subject: Re: [squid-users] Fedora > > Gustavo Lazarte wrote: >> I got the service working. Now my old configuration from version 2.4 is not >> working on 3.0 Stable 2. > > Please do not use 3.0.stable2 under any circumstances. It does not > perform authentication in any meaningful manner. > > For you should use something 3.0.stable7+ > > 3.0.stable9 is just out with the most current stability fixes.. > >> In theory the traffic was coming from a load balancer and hit the Proxy >> server. The proxy server then will request 10.2.0.140 for the content. >> >> When I try to start the service with my old configuration is having problems >> with the following lines, is the syntax different? >> >> acl all src 0.0.0.0/0.0.0.0 ***warning*** >> | acl manager proto cache_object >> | acl localhost src 127.0.0.1/255.255.255.255 acl to_localhost dst >> | 127.0.0.0/8 acl ssl_ports ports 443 563 acl safe_port port 80 acl >> | safe_port .... >> | acl connect method connect >> | acl mylan src 127.0.0.1 ***Fatal Error*** >> | acl mysites 10.2.0.140 *** Fatal Error*** >> | >> | http_access allow manager localhost >> | http_access deny manager >> | http_access deny !safe_port >> | http_access deny to_localhost >> | http_access allow mysites >> | http_access deny all >> | >> | http_reply_access allow MYLAN ***Fatal Error*** >> | http_reply_access allow all >> >> Even with the default config I am not able to telnet to port 80 on the squid >> server. > > Correct. If squid cannot read it's config it wont be able to start > operating. > > Use a newer version, and please indicate what the warning messages are. > My informed guess is listed below > > acl all src ... > ** fully built-in now. no need to specify. > > acl mylan src 127.0.0.1 > ** weird, check that line for extra text or invisible binary > characters. same for the other src one. > > http_reply_access allow MYLAN > http_reply_access allow all > > ** earlier failure of src ACL above may cause this > ** only the allow all is needed. > > Amos > > -- Please use Squid 2.7.STABLE4 or 3.0.STABLE9
