Hi,
I am struggling to see why my SDP is not being set correctly on the
INVITE to my supplier with Proxy-Authentication when I use uac_auth().
The initial INVITE to my supplier has correct SDP set by
rtpengine_manage. Then supplier replies with a 407. My failure route
correctly handles the Auth, and also calls NATMANAGE again... but this
time the SDP is unchanged and the private IP and original media
information from the original device is relayed to my supplier.
kamailio.cfg isbased on the default config. Running kamailio 5.4.6 and
using example from uac module for uac_auth.
My failure route calls NATMANAGE. Is there anything special about
uac_auth? Do I need some extra magic to apply the message body changes
after I have run rtpengine_manage().
====================
Extract of kamailio.cfg
failure_route[TRUNKAUTH] {
if (t_is_canceled()) {
exit;
}
route(NATMANAGE);
xlog("L_INFO","In failure route, just finshed NATMANAGE and now body is
$mb");
if(t_check_status("401|407")) {
# $avp(auser) = "test";
# $avp(apass) = "test";
# $avp(apass) = "36d0a02793542b4961e8348347236dbf";
if (uac_auth()) {
t_relay();
}
exit;
}
}
__________________________________________________________
Kamailio - Users Mailing List - Non Commercial Discussions
* [email protected]
Important: keep the mailing list in the recipients, do not reply only to the
sender!
Edit mailing list options or unsubscribe:
* https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users
