Here is an idea that I might throw out to those that might be interested.
In my frutile attempts to find small nut drivers in metric sizes that
seem to be very scarce I obtained some metric socket head cap screws. These
I turned the heads down to remove most of the excess material to nearly the
size of the screw diameter. If you turn them down too far they will break.
I then turned down the other end to remove about the first half of the
threads. I can now insert them into a General Tool pin vice (looks like a
jewelers screw driver with a collet on one end) The pin vice has two
different collets with four different size holes. I now have a very
functional small nut driver. I plan on doing the same thing with some small
SAE screws.
All I have to find now is the tiny little metric taps and dies. Any
Ideas????
Salty
Portland OR
