>Gary, if the valve is brass it would be preferable to just  use 600 
>grit on a piece of plate glass for the valve and  and  seat followed 
>with 1000 grit. Bon ami  with oil could be used too.  Running the 
>engine  on air while lapping is NOT good as some of the grit will 
>get into the cylinder and give accelerated wear,  Clean as you will, 
>some of the grit will stay in the cylinder walls, pistons and rings. 
>Too boot  the compound will also accelerate the wear on the valve 
>travel surfaces, it is far better to have an even smooth surface on 
>the valve chest face. The treatment of both surfaces should be done 
>in a figure eight movement and thoroughly cleaned. You will have 
>good performance for sure.


Any way, you had success! So who am I to comment!!



Geoff.

>




>I had valve leak problems with my Steamlines shay before I lapped the valve
>on plate glass using valve grinding compound.  I am not a machinist and do
>not have metal working machines so I took advice offered to me to lap the
>valve to ensure that it seats properly.  After grinding the valve flat I
>reassembled the engine and ran it on air with valve grinding compound (fine)
>for one (1) minute, then cleaned the engine and tested it under steam.  It
>still leaked so I repeated the fine grinding compound process for another
>minute on air.  The second minute sealed the valve very nicely.
>
>Adding a radiant burner to a butane burning engine, increased fuel
>efficiency and enabled the boiler to keep steam pressure up for the first
>time.  Radiant burner construction was easy with only hand tools or using
>simple power tools like a drill motor or Dremel.
>http://www.southernsteamtrains.com/index.htm Click on Reference then go to
>the Notes from the Unit Shop section and click on Radiant Poker Burners.
>The direct link
>http://www.southernsteamtrains.com/notes/radiantpokerburners.htm might also
>work.  The screens can be installed simply by wrapping the cut screens
>around a small tubing about the size of your burner then using your fingers
>to open up the screen just enough to clamp on the burner.  Without any other
>physical fastening method, my two screens have stayed in place for four
>years plus.  The unmodified burner kept steam pressure up for less than one
>lap around my 180' layout and total burn time was 13-18 minutes.  With the
>radiant burner pressure is always between 2-4 bar and run times are now
>34-38 minutes.  Burn less fuel, have more pressure.  How can that be beat?
>Two side effects are less heat in the exhaust and less butane burner roar.
>~ Gary - Steaming over Terror Trestle 
>http://community.webshots.com/user/raltzenthor 
>http://www.angelfire.com/or/trainguy/
>
>~I'm still trying to get it to run smoothly, but I am getting a large amount
>~of steam out of the stack and the boiler can't keep up, so it seems the
>~valve is not seating. I did polish the valve face with crocus cloth so I
>~know it will take a while for the valve to bed in.
>
>~Help me mister wizard!
>
>_______________________________________________
>SSLiveSteam mailing list
>Send messages: [email protected]
>Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
>Rules: http://www.45mm.com/sslivesteam_guide.html

_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to