Tony,

The castings that I used were purchased from Sulphur Springs, and were rough 10 
(or 12?) spoke castings. I had to bore the axle hole and made them press fit. I 
only had to turn two wheels for the project at hand. It really wasn't so hard 
to make two the same after I made a fixture and strategized the process. If I 
were out to make four identical wheels, you can be sure that I'd schedule some 
regular rest breaks between work periods to check tool alignments, bit 
sharpness, and to take a breather. As it was I stopped short of turning the two 
wheels to a "perfect" tread/flange profile, because I knew I'd go too far with 
one of them.

Steve




__________________________________________________________________
Switch to Netscape Internet Service.
As low as $9.95 a month -- Sign up today at http://isp.netscape.com/register

Netscape. Just the Net You Need.

New! Netscape Toolbar for Internet Explorer
Search from anywhere on the Web and block those annoying pop-ups.
Download now at http://channels.netscape.com/ns/search/install.jsp
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to