Dave,

Sorry I'm having to send this from my note book as the PC is striking
again.

I assume you are referring to the RONSON Valve.

It seems you may not have received my mail but If a std valve such as
is fitted to Accucraft locos does not fit but is almost the right size
then you have a standard European M5 x 0.5 thread The valve will cost
a few pennies from Ralph Reppingen or Axel Bretzler. These are the
only two possibilities. For me the better one is Reppingen simply
because the breather hole is at the bottom of the valve and not at the
side as in Accucraft valves. The valves with the vent hole on the
side can lead to filling problems if the thread that the valve is
screwed into is over 2mm long, because it can partly or even fully
cover the vent hole.  (some early C-16's had this problem). If all
else fails Dave I have one in my sticky little hand at this moment.


Your move.

Have a good one

 Bert                          mailto:[EMAIL PROTECTED]


_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to