Steam test today showed that there is a very tiny leak near one re-soldered 
joint. Possibly caused by the presence of soft soldered residue. Diameter of 
hole is probably tens of micrometers. It caused a minute steam oil weep, which 
I will ignore unless it gets worse. Apprehensive about inflicting even more 
damage if I try to repair it. (By comparison the cylinder heads leak worse. 
Tried Permatex to seal the heads but it didn't hold up to heat, pressure, 
and/or steam.)

I did install a proper threaded union to replace the silicone tubing between 
the superheater and lubricator. That went well and should hold up better than 
the silicone under high heat. I have found that when subjected to high heat 
silicone tubing adheres very well to copper tubing. Over time the silicone 
hardens and can disintegrate if flexed.

Steve


__________________________________________________________________
Switch to Netscape Internet Service.
As low as $9.95 a month -- Sign up today at http://isp.netscape.com/register

Netscape. Just the Net You Need.

New! Netscape Toolbar for Internet Explorer
Search from anywhere on the Web and block those annoying pop-ups.
Download now at http://channels.netscape.com/ns/search/install.jsp
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to