I can't help you with the grub screw (What we call a "set screw" on this  
side of the big pond) But for valve settings the slide valve should show a bare 
 
crack at the dead center positions. If the valve openings are not equal on 
both  ports that calls for adjustment of that nut on the valve stem. 
 
On my larger locomotive (LBSC's Virginia) there are drain cocks on each end  
of the cylinder and I put a plastic tube over the open drain cock and submerge 
 the free end in a container of water, apply air pressure from the shop 
supply to  the steam inlet to the cylinders. That way I can see just when the 
valve 
cracks  open as I rotate the drivers and bubbles show up on the end I am 
working on.  

John  Meacham
from the high deserts of Calif
12 inch Atlas lathe, mini mill, HF  band saw and a rusty file. 




************************************** See what's new at http://www.aol.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
http://postfix.45mm.com/pipermail/sslivesteam/attachments/20071023/092346a3/attachment.html
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to