Friends,
An oversize hole in a displacement/dead leg oiler can be corrected by inserting
a piece of wire into the hole so that it partially blocks the opening.
Experiment with wire that is of a diameter smaller than the hole to come up
with a size that blocks the hole enough to yield the desired oil flow rate.
The wire can be bent into a "U" or "Z" shape to keep it in place. One source
of small diameter wire is ordinary stranded electrical cord. The copper wire
strands are soft and will not corrode so just tease out a half inch or so from
a piece of scrap wire and see if one or two strands inserted into the oversize
hole will lessen the oil flow to a satisfactory rate.
V/r,
Casey Sterbenz
O Scale Kings #8 > From: [EMAIL PROTECTED]> To: [email protected]>
Date: Thu, 28 Aug 2008 21:43:26 -0500> Subject: [SSLiveSteam] (no subject)> >
To Dave Orwig,.> > Dave,> > I think you made a mistake of over drilling the
small steam inlet hole in the oilier. Make a very tiny hole like .015"
diameter. Then you might insulate the OD on the oilier to keep it warmer (less
condensation).> > Arthur---Mexico City
_________________________________________________________________
Get ideas on sharing photos from people like you. Find new ways to share.
http://www.windowslive.com/explore/photogallery/posts?ocid=TXT_TAGLM_WL_Photo_Gallery_082008
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://postfix.45mm.com/pipermail/sslivesteam/attachments/20080829/7cfb53ef/attachment.html
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html