On Sun, Aug 7, 2011 at 3:05 PM, Dmitry Eremin-Solenikov
<[email protected]> wrote:
> The pxa2xx_sharpsl driver part is also used on collie, which (as
> a StrongARM board) has different expectations for PCMCIA drivers.
> So, on collie place sharpsl_pcmcia_ops in .data section rather than
> in __initdata.
>
> Signed-off-by: Dmitry Eremin-Solenikov <[email protected]>
> Cc: [email protected]
Any comments on this patch?
> diff --git a/drivers/pcmcia/pxa2xx_sharpsl.c b/drivers/pcmcia/pxa2xx_sharpsl.c
> index 69ae2fd..f2405dc 100644
> --- a/drivers/pcmcia/pxa2xx_sharpsl.c
> +++ b/drivers/pcmcia/pxa2xx_sharpsl.c
> @@ -219,7 +219,11 @@ static void sharpsl_pcmcia_socket_suspend(struct
> soc_pcmcia_socket *skt)
> sharpsl_pcmcia_init_reset(skt);
> }
>
> +#ifdef CONFIG_SA1100_COLLIE
> +static struct pcmcia_low_level sharpsl_pcmcia_ops = {
> +#else
> static struct pcmcia_low_level sharpsl_pcmcia_ops __initdata = {
> +#endif
> .owner = THIS_MODULE,
> .hw_init = sharpsl_pcmcia_hw_init,
> .hw_shutdown = sharpsl_pcmcia_hw_shutdown,
> --
> 1.7.2.5
>
>
--
With best wishes
Dmitry
_______________________________________________
stable mailing list
[email protected]
http://linux.kernel.org/mailman/listinfo/stable
