Hello Anders Drejer
On 09-M�r-00, you wrote:
> Den 08-Mar-00 skrev Anders Drejer:
> This problem is now solved (changed the "ring" setting to 1 (was 3)),
> but I still have this very, very annoying printring problem (squezzed
> to half height).
Do you experience the same problem when viewing the fax? If you do, the
problem results from the resolution recognition of STFax. It was mentioned
earlier in this list, that STFax sometimes cannot recognize the resolution
of a fax, if it's less than half a page and received in independent mode.
If it was received in normal mode, the resolution is detected during
connection (perhaps ;). TurboPrint uses RastPort aspect ratio for printing,
so the printout looks the same as viewed on the monitor (if setup of TP is
correct. Look for H/W correction in TP-Prefs. But if this would be the
problem, all printouts would have incorrect aspect... :| )
Try to receive a full-page fax. Perhaps the half-height-problem will
disappear...
Regards
--
Wolfgang Hosemann
[EMAIL PROTECTED]
--
STFax Mailing List - http://www.active-net.co.uk/products/stfax
ML-Help: <[EMAIL PROTECTED]>, "HELP" or "LONGINDEX"
ML-Unsubscribe: <[EMAIL PROTECTED]>, "DEL" in mail body
