After checking dmesg it is trying to allocate IRQ 5 to
the SB driver it loads. Unfortunately SB chip is on
IRQ 7. What file do I edit to change this.. I'm still
fairly new to this whoel changing IRQ & hardware
configs in Linux.
Thanks
--- Tom Clements <[EMAIL PROTECTED]> wrote:
> On Wed, 06 September 2000, Andy wrote:
>
> >
> > I am having a bugger of a time configuring my
> sound
> > card on my laptop. It uses the ESS 1688 chipset
> which
> > is supported by storm. But when I go into SAS and
> try
> > and set it up I get the following error:
> >
> > /lib/modules/2.2.16-stom-ide/misc/sb.o:
> > init_module:Device or resource busy
> > /lib/modules/2.2.16-storm-ide/misc/sb.o:
> > insmod
> > /lib/modules/2.2.16-storm-ide/misc/sb.o:
> > failed
> > /lib/modules/2.2.16-storm-ide/misc/sb.o:
> > insmod sound-slot-0 failed
> >
> > any suggestions.
> > When I went to lsmod there are no sound modules
> loaded.
>
> The most common problem is wrong irq and dma
> settings. Check to see what irq's are used. You
> can use KDE control center or even try dmesg and
> check what is using what irq's. Your module won't
> load if these are not correct.
>
> TC
>
>
>
__________________________________________________________
> Get your FREE personalized e-mail at
> http://www.canada.com
>
>
> _______________________________________________
> Stormlinux-users-list mailing list
> [EMAIL PROTECTED]
>
http://www.stormix.com/community/lists/listinfo/stormlinux-users-list
__________________________________________________
Do You Yahoo!?
Yahoo! Mail - Free email you can access from anywhere!
http://mail.yahoo.com/
_______________________________________________
Stormlinux-users-list mailing list
[EMAIL PROTECTED]
http://www.stormix.com/community/lists/listinfo/stormlinux-users-list
