A correction to my last message. I get the following message when the
kernel loads. If I run in Windows, though, it is IRQ10 and the i/o is
0x1000-0X107F:
3c59x.c:v0.99H 24Jun00 Donald Becker and others
http://www.scyld.com/network/vortex.htmleth0: 3Com 3c905B Cyclone
100baseTx at 0xb000, 00:01:02:6f:2b:8e, IRQ 0 *** Warning: IRQ 0 is
unlikely to work! *** 8K byte-wide RAM 5:3 Rx:Tx split,
autoselect/Autonegotiate interface. MII transceiver found at address 24,
status 786d. MII transceiver found at address 0, status 786d. Enabling
bus-master transmits and whole-frame receives.eth0: Cannot allocate IRQ
#0eth0: Cannot allocate IRQ #0
Any suggestions?
Thanks again,
Glen
_______________________________________________
Stormlinux-users-list mailing list
[EMAIL PROTECTED]
http://www.stormix.com/community/lists/listinfo/stormlinux-users-list
