On 20/10/2017 12:22, Dirk Hohndel wrote:
it will show you a curses interface with the cmake variables for this project.
Half way down there should be NO_DOCS - what is it set to?
How about NO_USERMANUAL ?
If either is ON, move the curser down, press enter to toggle, then 'c' to
configure and 'g' to generate.
If both are set to OFF, then just press 'q' to quit
/D
NO_DOCS OFF
NO_MARBLE OFF
NO_PRINTING ON
NO_USERMANUAL ON
I use ccmake to change NO_USERMANUAL to OFF. (Had to do this as su
because of write privileges.)
Ececuted sudo ccmake again to make sure NO_USERMANUAL is OFF. It was.
Rebuilt Subsurface (build 1031). Problem not solved but I think it may
be finger trouble. This probably close to the reason for the problem.
Kind regards,
willem
--
This message and attachments are subject to a disclaimer.
Please refer to
http://upnet.up.ac.za/services/it/documentation/docs/004167.pdf for full
details.
_______________________________________________
subsurface mailing list
subsurface@subsurface-divelog.org
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
