On 05/02/2018 17:16, Jef Driesen wrote:
The dive header contains the number of sensors, and for each sensor a
bit to indicate whether it was calibrated, and the calibration value.
But your data only contains the number of sensors (1). *Both the
calibrated bit and the calibration value are zero. That's not what I
expected to see*.
I meant the data that came from the dive computer, and not some info
that is calculated by subsurface. The fact that some of your data
looks wrong, made me wonder whether there is some sort of data
corruption. Hence my question whether some other data (depth,
temperature, etc) looks wrong or not. If other data is clearly wrong
too, then data corruption might indeed be the cause.
Do you happen to have memory dumps downloaded in the past?
Jef
I will be using Shearwater again within the next week and cross-check. I
will also be diving the same Predator with a single sensor two weeks
from now. One thing that may be relevant is that the Shearwater has two
different calibration modes, one for 3 connected sensors (usually eCCR)
and another calibration mode for a single sensor. Perhaps the way the
information in memory differs between these two modes?? Is there
anything specific that I should look out for or do during the next 2 weeks??
Kibd regards,
willem
--
This message and attachments are subject to a disclaimer.
Please refer to
http://upnet.up.ac.za/services/it/documentation/docs/004167.pdf for full
details.
_______________________________________________
subsurface mailing list
subsurface@subsurface-divelog.org
http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
