Hello Matty,
if you only want a vehicle to repeat the same route you can just use the
"repeat" attribute for the route. For example:
<route id="bot_loop" edges="edge1 edge2 edge3 edge4 edge5 edge6
edge7 edge8" repeat="3">
<stop busStop="stop1" duration="15" />
<stop busStop="stop2" duration="15" />
</route>
This way you don't need a rerouter device.
Unfortunately I'm not familiar with the rerouter device and don't know why you
are getting this error.
Regards,
Giuliana
From: [email protected] [mailto:[email protected]] On
Behalf Of Matty Golub
Sent: Samstag, 19. September 2020 00:21
To: [email protected]
Subject: [sumo-user] routeProbReroute does not assign new route
Hello,
I am attempting to use a rerouter to put a single vehicle on a repeating
looping route. This is intended to simulate a shuttle service that repeats a
route in a neighborhood. I have generated a toy example from the "Driving In
Circles" tutorial and have one rerouter currently. I have tried multiple
configurations for the rerouter and it does not direct the vehicle to repeat
its route. I have also generated an extra route, called "extra" to test
rerouter functionality. This also is not successful. When I run the rerouter to
have the vehicle repeat its loop, I get these warnings when it crosses into the
edge where the rerouter is located:
Warning: busStop 'stop1' for vehicle 'LR_AV' on lane 'edge2_0' is not
downstream the current route.
Warning: busStop 'stop2' for vehicle 'LR_AV' on lane 'edge5_0' is not
downstream the current route.
(Note that the vehicle is programmed as a bus and the bus stops are on its
original route)
To me this indicates that there is a problem with how the vehicle interacts
with the rerouter. Since it disappears after reaching the end of the edge where
the rerouter is located (which is also the last edge on its route), it seems
the interface between the vehicle and the rerouter does not work.
Would someone be willing to look at the code and help me figure out how to use
the rerouter properly? I have attached all of the necessary files. It is a very
small network so all of the files are very small. Any help would be greatly
appreciated.
Sincerely,
Matty Golub
Here is the code for the rerouter, from the .add file. The actual file has more
in it, but this is what's necessary:
<additionals>
<vType id="LR_AV" width="2" length="7" vClass="bus"
personCapacity="8"/>
<!-"bot_loop" is the bottom loop (bottom half of the figure 8)
of the network -->
<route id="bot_loop" edges="edge1 edge2 edge3 edge4 edge5 edge6
edge7 edge8">
<stop busStop="stop1" duration="15" />
<stop busStop="stop2" duration="15" />
</route>
<rerouter id="rerouter_2" edges="edge8" vTypes="LR_AV"
probability="1">
<interval begin="0" end="1e9">
<routeProbReroute id="bot_loop"
probability="1"/>
</interval>
</rerouter>
</additionals>
_______________________________________________
sumo-user mailing list
[email protected]
To unsubscribe from this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user
