The intermodal routing algorithm requires all stops along the route to be known at loading time. It is therefore incompatible with using rerouters. I recommend defining your shuttle using route attributes 'repeat' and 'cycleTime' instead. Compared to a flow with periodicity this has the advantage of keeping each vehicle in the loop continuously.
Am Sa., 3. Okt. 2020 um 07:06 Uhr schrieb Matty Golub <[email protected]>: > Moderator: Please note that I sent this email on September 30th. The > moderator who reviewed it rejected it because I am not a subscriber to this > group. I followed up with a separate email to [email protected] > and attached the initial email I received confirming my subscription to > this mailing list. I also sent an email about rerouters a few weeks ago and > it was approved and ultimately answered. Furthermore, I went to the > eclipse.org site for this mailing list and it indicates that I am > subscribed. Please approve this email at your earliest convenience. > > > > Hello, > > > > I am trying to simulate the effect of having a looping shuttle route on > intermodal pedestrian trips in a neighborhood. I previously wrote to the > mailing list about how to use rerouters to generate one vehicle that > follows the same loop. The response was very helpful and I got my > simulation working, thank you. > > Now I am trying to add in the pedestrians and observe that the presence of > the shuttle loop has no impact on their trips. Before this iteration, I had > the shuttle programmed as a flow with a periodicity that approximated the > travel time of the loop. It was not exact, which is why I wanted to use > rerouters to keep one vehicle in a loop so it could be affected by traffic. > In the previous iteration, there was a noticeable impact on pedestrian > routing, where many pedestrians used the shuttle route(s) I programmed. > Now, with the looping route, none of the pedestrians behave differently. I > am not getting any warning or error messages so I am not sure what to do. > > > > Would someone be willing to look over one instance of my code? I am aiming > for three shuttle loops, but if I can just get one working I can fix the > rest. > > > > Any feedback or ideas is greatly appreciated. I can send my code out on > this thread at a later point as well. > > > > Thank you, > > Matty > > > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
