Thanks Jakob for your reply! I am setting the effort, but I found that the problem was the vehicles did not have a routing device, so I added it.
Thanks ! On Mon, 7 Dec 2020 at 07:21, Jakob Erdmann <namdre.s...@gmail.com> wrote: > All vehicles are able to reroute when asked to do so via TraCI. Possible > reasons why it doesn't happen for you: > - the vehicle has lots of stops or vias defined that anchor the route > - wrong effort values being used (default edge effort is 0). > > How are you setting the effort? > Did you check the effort in sumo-gui? > > Am So., 6. Dez. 2020 um 02:53 Uhr schrieb Jose Monreal Bailey < > jmonr...@gmail.com>: > >> Hey everyone, >> >> I was reading past emails where they asked about rerouting by effort. >> I am using TraaS, and when calling rerouteEffort with vehicle id, I do >> not see the vehicle re-routing even when the effort on all other edges is >> smaller than the ones it has already taken. >> >> Could it be because the route/flow is fixed, and it can not go against >> the rule of the defined route? >> >> Best regards, >> José >> _______________________________________________ >> sumo-user mailing list >> sumo-user@eclipse.org >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > sumo-user@eclipse.org > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list sumo-user@eclipse.org To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user