Hi folks,
Thanks very much in advance - I suspect that this question is annoyingly simple.
I'm trying to use NETCONVERT to convert a shapefile into a network file for
MATSim. I visited the NETCONVERT documentation
here<http://sumo.dlr.de/wiki/NETCONVERT> and
here<http://sumo.dlr.de/wiki/Networks/Import/ArcView>, but couldn't quite make
it work.
I tried three different approaches. The first two crashed immediately:
1.: [cid:[email protected]]
2.: [cid:[email protected]]
The third approach seems to have started working but then was taking more than
an hour on "computing node shapes", so I quit it. Or is this normal?
3.: [cid:[email protected]]
[cid:[email protected]]
Any thoughts on what I might be doing wrong?
Thanks again,
Gabor Debreczeni
This message, including any attachments hereto, may contain privileged and/or
confidential information and is intended solely for the attention and use of
the intended addressee(s). If you are not the intended addressee, you may
neither use, copy, nor deliver to anyone this message or any of its
attachments. In such case, you should immediately destroy this message and its
attachments and kindly notify the sender by reply mail. Unless made by a person
with actual authority conferred by Louis Berger, the information and statements
herein do not constitute a binding commitment or warranty by Louis Berger.
Louis Berger assumes no responsibility for any misperceptions, errors or
misunderstandings. You are urged to verify any information that is confusing
and report any errors/concerns to us in writing.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
sumo-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/sumo-user
