Hello, the gap is also controlled by the 'tau' parameter which defines the desired time-gap in seconds (whereas minGap defines the minimum standing gap in meters). Set a lower that corresponds to the desired gap (or an even lower gap) and the following distances should not increase. regards, Jakob
2017-09-12 19:21 GMT+02:00 Fatma Marzouk via sumo-user < [email protected]>: > Hello, > > Please I was trying to set a sumo scenario where a number of vehicle keep > the same speed and a constant and too small gap between them. > > For that I used the attribute minGap = "1" , sigma="0" and speedDev="0". > I also set the speed of the the first three vehicles to be less than the > others vehicles speeds. > > > However when I run the simulation I see that the gap is not constant and > keep increasing over the simulation time. > > Can anyone please tell me how to solve that. > > > Thank you in advance > > > Fatma MARWOUK > ᐧ > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > sumo-user mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/sumo-user > _______________________________________________ > sumo-user mailing list > [email protected] > To change your delivery options, retrieve your password, or unsubscribe > from this list, visit > https://dev.eclipse.org/mailman/listinfo/sumo-user > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ sumo-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/sumo-user
