the time parameter of traci.simulationStep uses milliseconds rather than seconds. regards, Jakob
2017-09-24 16:05 GMT+02:00 Lawrence Soon via sumo-user < [email protected]>: > Hi all, > > > I tried to perform traci simulation in every 20 seconds from 1s to 1001s > via traci4matlab using the below codes in MATLAB , yet it wont work, the > sumo simulation ends at 0s (not even started). I wish to run my code at 1s, > 21s, 41s, 61s, ..., 1001s in MATLAB (only for codes), bu in SUMO, the > simulation time to run per second basis in sumo. In other words, the SUMO > runs every second, but I m collecting the data via my MATLAB codes in even > 20 seconds. > > > How to make the code works? > > > for t=1:50 %Loop 50 times for ever 20 seconds > traci.simulationStep(20); %set timestep = 20s > > <something else> > end > traci.close(); > > Thank you > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > sumo-user mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/sumo-user > _______________________________________________ > sumo-user mailing list > [email protected] > To change your delivery options, retrieve your password, or unsubscribe > from this list, visit > https://dev.eclipse.org/mailman/listinfo/sumo-user > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ sumo-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/sumo-user
