Dear sundial friends,

Thank you very much for the positive opinions about my "Shepherd's
House" design.

Of course, the drawing is the standard one and can be made by any of the
well known sundial programs.

I have no DeltaCad macro especially prepared for Shepherd?s sundial. I
simply replaced the operators in another macro (for cylinder sundial)
where the coordinates of the points for the hour and date lines are
calculated.

After printing, I took the needed measurements and constructed the roof
to have a slope of 30 degrees (I used four equal sheets). Attached is a
scheme of one side of the pyramidal roof of the "Shepherd's house". The
angles alpha and beta are related, namely cos(alpha)=cot(beta), but
perhaps the easiest way to construct the roof is to compute PQ from
cos(alpha) = MP / PQ, i.e. PQ = MP / cos(alpha).

As you can see on the picture in my previous e-mail, it is needed to add
new hour labels. Their best position is in the middle of July strip.
Then each wall will have hour labels.

Let me comment also Fabio's remark:

> Another solution is to avoid to turn it, changing the diagram, it
> wouldn't be an altitude sundial like the shepherd one but it would be
> interesting.

This would be a dial with parallel gnomon. I have a DeltaCad macro for
such dial with arbitrary plane and gnomon on my page

www.math.bas.bg/complan/valhrist/mystuff.htm

You can see on the second attachment a completely unusable drawing if
the wall is facing South, the gnomon is horizontal, and the date is
close to the equinoxes! Try the much better case of vertical gnomon (do
not change the parameters in the macro).

I want to thank you again and to wish you health and success!

Valentin Hristov

<<attachment: roof.gif>>

<<attachment: hor_gn.gif>>

---------------------------------------------------
https://lists.uni-koeln.de/mailman/listinfo/sundial

Reply via email to