http://wiki.elphel.com/index.php?title=Usage_Tutorials
If your cameras flash image is not totally outdated you can also reflash over a web gui: http://blogs.elphel.com/2009/09/firmware-update-made-easier/ Regards Sebastian On Fri, Oct 15, 2010 at 01:53, Gary Crum <[email protected]> wrote: > Hi All, members of [email protected], > I am working with an Elphel 353 camera, and the ZoneMinder 1.24.2 software > for video surveillance running on a separate computer running Linux Mint 9 > (based on Ubuntu 10.04). Any related interest here? > > My main question: Can anyone point me to instructions for flashing new code > to the 353 camera? I found and followed instructions for obtaining and > building source code, but I don't see the link to flashing and testing > instructions. > > > Read on for more details! > > The Elphel wiki page about ZoneMinder use here is good, and suggests that > the best solution for this setup will be to use the relatively new RTSP > streaming support in both the camera and ZoneMinder: > http://wiki.elphel.com/index.php?title=Elphel_cameras_and_Zoneminder > > I have tried using the RTP/RTSP solution, and with verbose debugging enabled > in ZoneMinder I see this error in log files: > 10/11/10 17:14:43.184461 zmc_m4[6275].FAT-zm_rtsp.cpp/471 [Unable to get RTP > Info identifier from response 'RTSP/1.0 200 OK > > I obtained source code to ZoneMinder (using "apt-get source --compile > zoneminder"), changed it to not require the RTP Info identifier, but then I > see failure of the ffmpeg MJPEG codec to decode frames. I wasn't quite able > to enable full debugging in the ffmpeg library as used by ZoneMinder. > > So, now I want to go at it from the other side, looking at the > implementation of RTSP in the Elphel 353 camera. I "dove in" and setup my > development environment for the camera firmware and compiled it all. > Everything in KDevelop is looking good, free software is great. I see the > relatively new implementation of RTSP in the source file > apps/astreamer/rtsp.cpp, with many commented out lines, maybe I can help > improve this code and more fully conform to the RTSP specification. (For > example, the RTSP specification at http://www.ietf.org/rfc/rfc2326.txt does > indeed require an RTP-Info field, in section 12.33.) > > > I have not yet flashed the Elphel 353 camera with the code I have built, can > anyone point me at instructions for doing this? I think I came across these > instructions at one time, but today I don't see the instructions, looking at > http://wiki.elphel.com/index.php?title=Main_Page . > > The firmware on the camera I am using is release 8.0.4, and I just checked > out and built the current 8.0.8 software using CVS. > > Thanks, > -Gary > [email protected] or [email protected] > tel. (801)449-1426 > > _______________________________________________ > Support-list mailing list > [email protected] > http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com > > _______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
