Hi Andrey, I hope all is well.
>From the following link ( http://wiki.elphel.com/index.php?title=10369#Example_-_setting_SATA_to_be_IDE_slave_.28needed_if_bottom_CF_card_or_internal_HDD_is_installed.29) , Do I just click the link on that page? It shows me a page where it says the following: - <i2c> <width>8</width> <bus>1</bus> <slave>0x40</slave> <data>222</data> <rdata>222</rdata> <hex_data>0xde</hex_data> </i2c> Any thoughts? Thanks On Sun, Apr 17, 2011 at 10:46 PM, John M <[email protected]> wrote: > Hello Andrey, > > Thank you for your response. I attached the report to this email. > > - As for the SATA, I did power it before the camera was booted. I also > tried powering it after the camera was booted as well. > - I have one CF card but I also have a compass. > > I tried setting the SATA as IDE slave and then I reboot from the system > preferences. It doesnt seem to recognize the HDD. Any thoughts? > > Thanks > > > On Sat, Apr 9, 2011 at 9:30 PM, Andrey Filippov < > [email protected]> wrote: > >> John, >> >> Can you please send the dmesg output (i,e. from >> c<http://192.168.0.9/camerasetup/setup.php?page=report> >> )? >> >> Did you have the SATA disk powered before camera was booted? >> Do you have just one CF card? >> >> It seems that both devices try to be IDE master, you may try to reassign >> SATA to be IDE slave >> >> http://wiki.elphel.com/index.php?title=10369#Example_-_setting_SATA_to_be_IDE_slave_.28needed_if_bottom_CF_card_or_internal_HDD_is_installed.29 >> : >> >> and watch dmesg again. If that works (not very convenient - you have to >> boot then re-boot), and you do not have compass in the camera, you may take >> off the top camera cover and move CF card from the bottom to the top slot - >> it will be detected as IDE slave (hdb in the camera). >> >> Andrey >> >> >> >> >> On Thu, Apr 7, 2011 at 9:24 AM, John M <[email protected]> wrote: >> >>> Hi, >>> >>> I was hoping if you could help us out with setting up an external HDD on >>> our model 353. >>> >>> We have a WD 2.5 Scorpio Blue 500 GB HDD that is connected to the camera >>> through SATA and is powered externally. We also have an onboard CF 8GB card >>> thats installed that came with the camera. We can seem to get the camera to >>> identify the storage device, we tried following the steps on this link ( >>> http://wiki.elphel.com/index.php?title=HDD_Format) but it will only >>> identify hda and hda1 (which are the CF card). Any help would be >>> appreciated. >>> >>> Thanks! >>> >>> _______________________________________________ >>> Support-list mailing list >>> [email protected] >>> >>> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com >>> >>> >> >
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
