Woodrow, What is the cable length? 30mm? Could you please send an image from the sensor in test mode? (You can enable test mode through http://cameraip/parsedit.php - find TESTSENSOR parameter and set it to 0x10008 or in telnet or ssh session type "fpcf -i2cw16 48a0 41" (switch back "fpcf -i2cw16 48a0 0") where "48" is sensor's i2c address (shifted by 1 bit to the right) and "a0" is the test mode register).
Regards, Oleg On 6 December 2011 12:24, Douglass, Woodrow <[email protected]> wrote: > Hello all, > > I am trying to adjust the clock phase on my elphel 353 camera. I am using > the 7.1.5 firmware. > > I followed the instructions on this site: > http://wiki.elphel.com/index.php?title=Adjusting_sensor_clock_phase > > It doesn't seem to make a difference, my picture is still purple. I have > adjusted the 32 bits at 0x201, as well as using P_SENSOR_PHASE (at 74, per > c313a.h). neither seem to affect my picture... > > Do you have any ideas of what i should try next? > > Thanks a lot, > Woody > > _______________________________________________ > Support-list mailing list > [email protected] > http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com > >
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
