J B <[EMAIL PROTECTED]> writes: > > I just downloaded and installed Freenet and am unable to download the readme > file to figure it out.
There should be a README file in the main freenet directory .. it's more a collection of notes than an exhaustive manual though. I would point you to http://freenethelp.org but it seems to be down again :/ You might want to check it later. There's also the new official freenet wiki (http://freenetproject.org/wiki) but since it's new there's not a lot of info on it yet. > I keep getting Route Not Found and Couldn't Retrieve > Key errors. This is normal for relatively new nodes. To begin with they have nothing in their datastores, are unknown to the network and don't know which nodes to route requests to. These things improve as they "integrate" by learning network characteristics and to some extent develop their own specialisms (parts of the keyspace they are good at serving.) In other words, leave your node running for quite a long time and you should see it improve. Ideally freenet should be left running 24/7 on a dedicated computer, but more realistic for most people is that after a couple of days total uptime it should be reasonably well integrated and thereafter it should work acceptably when run semi-regularly for a few hours at a time. (Some freesite authors report successfully using freenet like this.) Even after this integration period, you should be aware that freenet 0.5 is usually slow and you will still see the occassional DNF or RNF. Freenet 0.7 performance should theoretically be better once it's release quality, although I personally suspect the darknet will be faster than the opennet, maybe quite significantly (better routing, less churn, friend-peers may share some of your interests.) Basic optimisations I'd recommend (some based on windows) : 1.)Make your datastore as big as you reasonably can, so that content blocks are magically cached locally before you even know you want them. 2.)Give it as much memory as you reasonably can (edit the JavaMem line in Flaunch.ini to e.g. JavaMem=350) because fred can be very I/O intensive. 3.)Make sure outputBandwidthLimit is set to something reasonable in freenet.ini (read the comments). You can set this with NodeConfig under the 'advanced' tab or something like that (yes I know, it should be much easier/more obvious) 4.)Again in freenet.ini / NodeConfig, make sure your ipAddress is set to your external IP and that your listenPort is forwarded / allowed through any NAT / firewall you may have. If you don't have a static external IP, use a free dynamic DNS service like http://dyndns.org and make sure you keep it up to date. You can tell if there's an issue here if there are never any incoming connections on your "Open Connections" web interface page. 5.)Setting doCPULoad=true in freenet.ini (don't know if there's a NodeConfig entry for this) is generally a good idea, if it's not set already. If you're on *nix the same things apply except the configuration file is freenet.conf, and you set maximum memory with the -Xmx flag in start-freenet.sh. Bob _______________________________________________ Support mailing list Support@freenetproject.org http://news.gmane.org/gmane.network.freenet.support Unsubscribe at http://dodo.freenetproject.org/cgi-bin/mailman/listinfo/support Or mailto:[EMAIL PROTECTED]