On Sun, Sep 7, 2008 at 5:07 AM, Offray Vladimir Luna Cárdenas <[EMAIL PROTECTED]> wrote: [...] > usb0 Link encap:Ethernet direcciónHW 0E:8D:A0:04:CF:A4 > inet addr:192.168.0.200 Difusión:192.168.0.255 > Mask:255.255.255.0 > inet6 addr: fe80::c8d:a0ff:fe04:cfa4/64 Scope:Link > UP DIFUSIÓN CORRIENDO MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:214612 dropped:0 overruns:0 frame:0 > TX packets:1 errors:77 dropped:0 overruns:0 carrier:0 > colisiones:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:90 (90.0 b) > > > and this is my /etc/network/interfaces on Desktop: > > auto lo > iface lo inet loopback > > > #Conexion al Freerunner > > iface usb0 inet static > address 192.168.0.202 > netmask 255.255.255.0 > network 192.168.0.0 > post-up iptables -A POSTROUTING -t nat -j MASQUERADE -s > 192.168.0.0/24 > post-up echo 1 > /proc/sys/net/ipv4/ip_forward > post-up iptables -P FORWARD ACCEPT > /etc/network/interfaces (END)
Are you sure this worked previously? Looks to me like it shouldn't :-) Is the part below "#Conexion al Freerunner" the interfaces file **on the phone**? The IP address is certainly what the phone is supposed to use by default. If you have set up this IP address on your desktop ("host") side of the USB networking connection, then no communications will be possible if both ends of the connection have the same IP address. The post-up commands in this block should be run on your desktop host, yes... but the IP address there is the wrong one, to the best of my knowledge. On the other hand, your ifconfig output shows a correct IP address of 192.168.0.200... so your post is quite confusing to me :-) I would strongly recommend you check your configuration with the instructions at http://wiki.openmoko.org/wiki/USB_Networking#Openmoko_Networking_Setup At least you need to change that IP address in your desktop interfaces file to 192.168.1.200... Also pay attention to the Firewall Issues section in that page, since I have made the same mistake in the past - I have had iptables rules blocking packets from the phone... Hope this helps Ed. _______________________________________________ support mailing list support@lists.openmoko.org https://lists.openmoko.org/mailman/listinfo/support