-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Somebody in the thread at some point said: | Hi xiangfu: | |> i receive a new debug board and the serial console is work. |> yesterday i try to use openocd but it is not work. |> - -------------------------------------------------------------------------- | |> Bus 002 Device 015: ID 0403:6010 Future Technology Devices |> International, Ltd FT2232C Dual USB-UART/FIFO IC | | Your debug board is not programed or been cleaned eeprom, the USB ID is | default FTDI ID 0403:6010 | |> Unable to find FTDI devices under given vendor/product id: 0x1457/0x5118 |> Retrying with default FTDI id. |> Used eeprom space: 102 bytes |> FTDI write eeprom: 0 |> Writing to file: neo1973_debug_board_v2.eeprom |> FTDI close: 0 | | Same problem, it's not 0x1457/0x5118 anymore. so flashing fail. | | You could modify the openocd.cfg or openocd-debugv2.cfg file , | ftdi_vid_pid 0x0403 0x6010 make it work without refresh eeprom into | correct USB ID.
Good job Tony answered, my experience is with exactly one rev2 debug board that came from Willie with EEPROM set up so it's a much education for me as you Xiangfu :-) - -Andy -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.9 (GNU/Linux) Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org iEYEARECAAYFAkjMzE4ACgkQOjLpvpq7dMoaogCfcIsCKLHzFPHQDSqUBPSboq3Q rFIAoJMkHDM9DvoRFkdUyCqvX+oMFCao =PQ5g -----END PGP SIGNATURE----- _______________________________________________ support mailing list support@lists.openmoko.org https://lists.openmoko.org/mailman/listinfo/support