My apologies, this appears to be related to the topic "Traffic Shaping,
killing my DSL link speed to less than 100k"
My 3000/500 line is running 200/20 with my traffic shaping rules enabled (!)
I will turn it off, go back and read that thread in detail.
At 04:33 PM 10/28/2005, Bill Plein wrote:
I upgraded to 0.89.2 on my WRAP embedded (via update, not full install)
When attempting to set up traffic shaping (to see if it worked better than
prior installs I've tried), I get this:
Warning: Cannot modify header information - headers already sent by
(output started at /etc/inc/filter.inc:613) in
/usr/local/www/wizard.php(89) : eval()'d code on line 1
followed by
Either your LAN or WAN interface doesn't support ALTQ. The wizard cannot
continue.
Then if I go to my Traffic Shaper page, it shows everything that was set
up by the traffic shaper!
My WRAP interfaces are set up as:
LAN -> sis0 -> <http://192.168.0.1>192.168.0.1
WAN -> sis1 -> <http://64.142.26.224>64.142.26.224
OPT1 -> sis2 -> (DMZ)
The DMZ is bridged with the WAN
Traffic shaping used to work with WRAP, any ideas?
--
--
Bill Plein
--
[EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
