When in doubt, you can sync daily... To stay actual... -----Ursprüngliche Nachricht----- Von: Dimitri Rodis [mailto:[EMAIL PROTECTED] Gesendet: Montag, 12. Juni 2006 19:10 An: support@pfsense.com Betreff: RE: [pfSense Support] Possible Bug in status_queues.php page?
See below.. and I quote "I did a sync up to releng_1 (because they use traffic shaping)" It was a full install of Beta 4 with a sync up to releng_1. Version reads as follows: 1.0-RC1 built on Mon May 8 22:37:25 UTC 2006 Do I need to sync again? I just ran the sync on Saturday.. -----Original Message----- From: Scott Ullrich [mailto:[EMAIL PROTECTED] Sent: Monday, June 12, 2006 6:39 AM To: support@pfsense.com Subject: Re: [pfSense Support] Possible Bug in status_queues.php page? <broken_record> There was a number of traffic shaping bugs fixed after beta 4. If this is a full installation then run cvs_sync.sh releng_1 </broken_record> On 6/12/06, Dimitri Rodis <[EMAIL PROTECTED]> wrote: > I have a pfSense box running at a customer's site, and I have opened > wan tcp 8000 --> lan interface of router tcp 443 for remote > administration of the pfSense box (so in my browser from my office I > type https://www.customer.com:8000 for the purpose of this example). I > did a sync up to releng_1 (because they use traffic shaping), and > whenever I go to the status_queues.php page in IE, the browser hangs > for 5-10 seconds, then responds for about half a second, and then > hangs (and the cycle repeats). I presume there's some sort of AJAX > code or something that updates these graphs, but I'm guessing that the > code is choking up IE because it isn't expecting to communicate on > ports other than 80 or 443.. ??? > > Any repros, or am I smoking crack here? (I tried it from my machine at > home, and it does the same thing) > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] For additional > commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
