Ok so the routing would be done how .. can you guys give me an example of setting up routing, so the two 5ghz panels will talk to each other. If not can you shoot me a link so I can learn on my own?
Thanks in advance.
On 10/23/06, Alan Walters <
[EMAIL PROTECTED]> wrote:
Does anyone run the ubiquity cards successfully with good power output
on pfsense.
We are seeing very poor power control with cm9's on pfsense release-1.
Rssi is 6-10 dbm less that staros or MikroTik on the same hardware.
We had not tried ubiquity cards as we had understood there was a problem
with power controlon them with the version of atheros hal pfsense was
using.
Am I mistaken.
-----Original Message-----s
From: Holger Bauer [mailto: [EMAIL PROTECTED]]
Sent: 23 October 2006 20:11
To: [email protected]
Subject: RE: [pfSense Support] New to this :)
Afaik you only can route between 2 wireless interfaces as you only can
bridge an interface to another one if it is in accesspointmode. This is
a driverlimitation and nothing we can fix unless the driver itself gets
fixed.
Make sure you have some very good powersupplies with 2 high power cards
on the wraps.
Holger
-----Original Message-----
From: NobleMan [mailto:[EMAIL PROTECTED] ]
Sent: Monday, October 23, 2006 3:37 PM
To: [email protected]
Subject: [pfSense Support] New to this :)
Hey guys,
I have purchased this equipment :
2 of these : WRAP.1E-1 = 2 LAN / 2 miniPCI
2 of these : Ubiquiti Networks SuperRange5 802.11a 400mW High Power
Atheros Wireless mini-pci card
2 of these : Ubiquiti Networks SuperRange2 802.11b/g 400mW High Power
Atheros Wireless mini-pci card
2 of these : 5ghz directional antennas
2 of these : 2.4 Omni directional antennas
Flash cards etc ..
My question is : I want to be able to use the 5ghz as the back haul and
the 2.4 for client access. I have downloaded your software and can not
figure out how to create a wireless bridge between the two wrap cards.
First of all, can it be done, and if so .. how ?
Thanks,
Ken
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
