I have configured a WRAP router for the first time. pfSense IP is 192.168.0.22
WiFi IP 192.168.10.1 WAN or sis1 10.1.10.2 This is an internal IP for testing and learning now to be set to external later. My mode is Access Point and am using ath0 as WiFi CM9 card. I can ping 192.168.0.22 from a box on that subnet. I can't ping either of the other IP's. I have bridged WiFi ath0 to LAN ip 192.168.10.1 sis0. AND Under interfaces LAN I set to bridge with OPT1. I am not sure why this would need to be set to bridge on both Web Gui pages? I have added firewall rules for LAN IF 192.168.10.1 Proto Source Port Destination Port Gateway Description* LAN Net * * * * Default LAN any WAN IF Proto Source Port Destination Port Gateway Description TCP * * * * 10.1.10.1 OPT1 IF Proto Source Port Destination Port Gateway Description TCP * * * * 10.1.10.1 The bottom of the firewall rule page says: You will also need firewall rules for an interface in bridged mode as the firewall acts as a filtering bridge I can't seem to figure out where in the GUI to set that rule? I have different IP subnets set up on the LAN and OPT1 IF's so I can later try to seperate that traffic and have each access the internet but not access each other. Thanks
