I do remember seeing something in FreeBSD release notes about ALTQ support being added to sf. Thanks, Bill and Scott. I'm confident it will turn out fine.
Bill Marquette wrote: > multicast - I've seen bad drivers out there in the past (usually it's > a few lines of code missing somewhere in the driver). Honestly, you'd > be more likely to have issues with ALTQ than with CARP, but it's > certainly possible. Good luck. > > --Bill > > On 6/29/07, Chris Daniel <[EMAIL PROTECTED]> wrote: >> Thanks for the reply, Scott. I'd love to go with Intel, but their >> prices for dual-port cards (around 150 USD) are a little too high for >> the moment. I was more wondering if CARP even does anything that a NIC >> might not support; I doubt it, but I don't know enough about it to say >> definitively. We'll see how it turns out. Thanks again. >> >> Scott Ullrich wrote: >> > On 6/28/07, Chris Daniel <[EMAIL PROTECTED]> wrote: >> >> Someone mentioned to me that he vaguely recalled there being an issue >> >> with CARP and some drivers. Just to be safe, I'd like to clarify >> whether >> >> there should be any compatibility problems with NICs using the sf(4) >> >> driver and CARP -- I've looked on the web, but haven't found >> anything. >> >> I'm looking at buying a couple of Adaptec ANA-62022 dual-port >> NICs, and >> >> want to make sure they will work in my CARP cluster. Thanks in >> advance. >> > >> > I do not have any experience with these cards but I highly recommend >> > going with Intel which are known to work OK. >> > >> > Scott >> > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]