Hi Chirs,

1. I have a Server called 'Max' - when adding this to the aliases (as I have prev done under mono) I would get an error on the reload of the config :( It would appear I am unable to add this host name as an alias. I presume max is a reserved word ? However the only workaround I can do is not to have an alias for this host and enter the ip address for now - which I can live with
(Just wanted to point out in case this was a bug or error).


There are certain keywords that can't be used in an alias, looks like
our input validation missed one. Ticket opened, thanks for the report.

No worries, glad it helped :)


I have the relevant entries in Virtual IPs (Proxy ARP) and set the required rules for Outbound NAT - but they seem to get ignored, however as I said I do have this working fine at the mo under mono so I think its correct how I
have it setup :(


It's the same to configure as in m0n0, and it works fine. How do you
have it setup?

Ok... well under m0n0 I have the following:

.190 is the firewall WAN IP

Under Proxy ARP I have

.186
.187
.188
.189

So I created these under the Virtual IP section in the interface - and selected ARP as the option ?. (Working from memory here, please bear with me)

In m0no:

Under NAT - OUTBOUND NAT I have the following entries.

INTERFACE - SOURCE - DESTINATION - TARGET - DESC

WAN - 192.168.102.3/32 - * - x.x.x.186 - Orion -> .186

WAN - 192.168.102.10/32 - * - x.x.x.187 - Pegasus -> .187

WAN - 192.168.102.2/32 - * - x.x.x.188 - Max -> .188

WAN - 192.168.102.14/32 - * - x.x.x.189 - Lyra -> .189

So if I SSH into any of these boxes and launch $> lynx http://www.whatismyip.com - each box reports the correct WAN IP I require... so appears to be fine.

However under pfSense - all the boxes report (using the same method above) .190 - which is the firewall WAN IP

Enable advanced outbound NAT - Ticked

Thanks for you help with this...

Regards

Matt

---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]

Reply via email to